Vet någon om det finns det någon verkstad som kan felsöka kod 27 och kod 51
Bilen står fast i Borlänge och fått felkoderna av Mazda där !!!Som aldrig skruvat rx men fick koderna alltid något hm ...........
har tittat på fesökningen problemet och sett lösningar tyvärr jag bor i Stockholm . Så meck möjligheterna är små
ove
:(
Hej
Är det Stefans gamla cab? ( Hedemora )
Han har frågat om jag har nån möjlighet att kolla på den och det kanke inte är omöjligt men det finns risk att det blir framåt i tiden.
Hittade detta på www.fc3spro.com
http://www.johnr.com/cpucodes.html
The Codes - from the 1990 Service Manual (86-88 do NOT match!)
Code - Input Device - Fail-safe operation mode
01 - Ignition Coil (Trailing) - Trailing ignition pulse cut
02 - Crank Angle Sensor (Ne) - Fuel Injection and ignition cut
03 - Crank Angle Sensor (G) - Fuel Injection and ignition cut
08 - Airflow Meter (AFM) - Basic Fuel Injection and fixed timing (Cripple mode)
09 - Water Thermosensor - Coolant temp fixed at 176F
10 - Intake Air Thermosensor (AFM) - Intake air fixed at 68F
11 - Intake Air Thermosensor (Engine) - Intake air fixed at 68F
12 - Throttle Sensor (TPS) Full Range - Fixed at 20% open
13 - Pressure Sensor (intake manifold pressure) - Fixed at 29.9 inHg
14 - Atmospheric Pressure Sensor (Inside of ECU) - Fixed at 29.9 inHg
15 - Oxygen Sensor - Feedback cancelled
17 - Feedback System (poss O2 sensor) - Feedback cancelled
18 - Throttle Sensor (TPS) Narrow Range - Fixed at full-open
20 - Metering Oil Pump (MOP) position sensor - Basic Fuel Inj and fixed timing
27 - MOP (General) - Basic Fuel Injection and fixed timing
37 - MOP (General) - Basic Fuel Injection and fixed timing
Code - Output Device
25 - Solenoid, Pressure Regulator Control
26 - MOP (Step Motor)
30 - Solenoid, Split Air Valve
31 - Solenoid, Relief Valve
32 - Solenoid, Switch Valve
33 - Solenoid, Port Air Valve
34 - Solenoid, Bypass Air Control (BAC) Valve
38 - Solenoid, Accelerated Warm-up System (AWS)
40 - Solenoid, Auxiliary Port (6PI) Valve
41 - Solenoid, Variable Dynamic Effect Intake (VDI)
51 - Fuel pump resistor relay
71 - Injector (Front secondary)
73 - Injector (Rear secondary)
MVH//Mattias
Montegoblue FD -94 US Touring
messenger: thulle@hotmail.com
För mig att Stefan sa nått i stil i med:
Den går bra när den är kall men när den blir varm varvar den ej över 2,500?
går den bra/rent under 2,500 när den är varm?
Korrigera mig gärna så kanske det är nån som varit med om nått liknande som kan komma med tips
//Mattias
Montegoblue FD -94 US Touring
messenger: thulle@hotmail.com